Summit WM3000 Series Controller System Reference Guide 265
6 Click the Add button to define a new peer or server configuration that can be added to the existing
configurations displayed within the NTP Neighbor tab.For more information, see “Adding an NTP
Neighbor” on page 265.
Adding an NTP Neighbor
To add a new NTP peer or server neighbor configuration to those available for synchronization:
1 Select Services > Secure NTP from the main menu tree.
2 Select the NTP Neighbor tab.
3 Click the Add button.
4 Select the Peer checkbox if the SNTP neighbor is a peer to the controller (non FTP server) within the
controller’s current subnet.
5 Select the Server checkbox if the neighbor is a server within the controller’s current subnet.
6 Select the Broadcast Server checkbox to allow the controller to listen over the network for NTP
broadcast traffic.
The controller’s NTP configuration can be defined to use broadcast messages instead of messaging
between fixed NTP synchronization resource addresses. Use a NTP broadcast to listen for NTP
To Next Page
Loading...