Controller Services
Summit WM3000 Series Controller System Reference Guide280
4 Refer to the following redundancy member information:
IP Address
Displays the IP addresses of the members of the redundancy group. There
are a minimum of 2 members needed to define a redundancy group,
including this current module.
Status
Displays the current status of this group member. This status could have
the following values:
•
Configured
- The member is configured on the current wireless service
module.
•
Seen
- Heartbeats can be exchanged between the current controller
and this member.
•
Invalid
- Critical redundancy configuration parameter(s) of the peer
(heartbeat time, discovery time, hold time, Redundancy ID,
Redundancy Protocol version of this member) do not match this
controller’s parameters.
•
Not Seen
- The member is no more seen by this controller.
•
Established
- The member is fully established with this current module
and licensing information already been exchanged between this
controller and the member.
AP Adoption Count
Displays the number of Access Points adopted by this member.
Adoption Capacity
Displays the maximum number of Access Points this member is licensed
to adopt. For information on licensing rules impacting redundancy group
members, see “Redundancy Group License Aggregation Rules” on
page 282.
To Next Page
Loading...