Controller Services
Summit WM3000 Series Controller System Reference Guide304
b To remove a MAC Address from the MU MAC table select a MAC Address from the table and
click the Delete button to remove that MU. This table is disabled when the Locate All MUs
checkbox is selected.
Once SOLE has been enabled MUs found by the locationing engine will be displayed in the Located MUs
table at the bottom of the page. For each located MU the following information is displayed:
Zone configuration can be defined using the CLI interface only. For information on Zone Configuration please see
the Summit WM3000 Series Controller CLI Reference Guide.
Configuring Aeroscout Parameters
To configure the controller to work with an external Aeroscout RTLS engine:
1 Services > RTLS from the main menu tree.
MAC
Lists the MAC Addresses of all MUs which have been located by the
controller.
Location:
X Coordinate
Displays the value of the X Coordinate for each located MU. The X
coordinate is relative to the origin point of 0,0 in the upper left corner of
the site map.
Location:
Y Coordinate
Displays the value of the Y Coordinate for each located MU. The Y
coordinate is relative to the origin point of 0,0 in the upper left corner of
the site map.
Timestamp
Displays the last time for each MU that its location was computed by the
controller.
Zone
Lists the last known zone for each located MU. Zone configuration can be
defined using the CLI interface only. When no zones are configured, the
controller defaults the entire site to Zone 0.
To Next Page
Loading...