Summit WM3000 Series Controller System Reference Guide 315
Approved APs
Those Access Points detected and approved for operation within the controller managed network can
be separately displayed to assess the reporting (detecting) AP, the channel of operation, the last time the
AP was observed on the network and the ESSID. Use this information to assess if an approved Access
Point was incorrectly defined as approved and requires categorization as an unapproved and
disallowed AP.
To review the attributes of allowed APs:
1 Select Security > Access Point Detection from the main menu.
2 Select the Approved APs tab.
3 The Approved APs table displays the following information:
BSS MAC Address
Displays the MAC Address of approved APs. These MAC addresses are
APs observed on the network meeting the criteria (MAC and ESSIDs) of
allowed APs.
Reporting Radio
Displays the numerical value assigned to the radio used with the specific
device MAC Address and SSID listed for this approved AP.
Channel
Displays the channel the approved AP is currently transmitting on. If this
device is operating on a channel not frequently used within your network
segment, perhaps the device is correctly defined as an approved AP.
Last Seen (Seconds)
Displays the time (in seconds) the approved AP was last seen on the
network.
ESSID
Displays the SSID of each approved AP.
To Next Page
Loading...