Summit WM3000 Series Controller System Reference Guide 331
4 Refer to the following information as displayed within the Attach tab:
:
5 Select an interface and click on Edit to modify the ACL interface, IP ACL and MAC ACL values.
6 Select an interface and click the Delete button to delete the interface configuration from the controller.
7 Click on Add button to add an physical or VLAN interface to the controller. For more information,
see “Adding a New ACL Layer 2/Layer 3 Configuration” on page 331.
Adding a New ACL Layer 2/Layer 3 Configuration
After creating an ACL, it can be applied to one or more interfaces. On a Layer 3 interface/ Layer 2
interface, ACLs can be applied only in an inbound direction. To add an ACL interface to the controller:
1 Select Security > Wireless Firewall from the main menu tree.
2 Click the Security Policy tab.
3 Click the Attach-L2/L3 tab.
Interface
The interface to which the controller is configured. It can be one of the
following:
• ge 1-8
• up 1
•
vlan1
(or any additional VLANs that have been created)
IP ACL
Displays the IP ACL configured as the inbound IP for the layer 2 or layer
3 interface.
MAC ACL
Displays the MAC ACL to be configured as the MAC IP for the layer 2
interface.
To Next Page
Loading...