Controller Security
Summit WM3000 Series Controller System Reference Guide338
6 Refer to the Status field for the state of the requests made from applet. This field displays error
messages if something goes wrong in the transaction between the applet and the controller.
7 Click OK to use the changes to the running configuration and close the dialog.
8 Click Cancel to close the dialog without committing updates to the running configuration.
Configuring Wireless Filters
Use filters to either allow or deny a MAC address (or groups of MAC addresses) from associating with
the controller. Refer to the Wireless Filters screen to review the properties of existing controller filters. A
filter can be selected from those available and edited or deleted. Additionally, a new filter can be added
if an existing filter does not adequately express the MU’s address range required.
To display the Wireless Filters main page:
1 Select Security > Wireless Firewall from the main menu tree.
2 Click on the Security Policy tab.
3 Click on the Wireless Filters tab.
4 The Wireless Filters tab contains the following read-only information:
Encryption
Select an Encryption filter, if any, to apply to the role.
Available Encryption filters are:
•
Equals
: The role will only be applied when the Encryption type
matches the exact Encryption method specified in the role
•
Not Equals
: The role will only be applied when the Encryption type
does not match the exact Encryption method specified in the role
•
Any
: The role will be applied to any Encryption type
To Next Page
Loading...