Controller Security
Summit WM3000 Series Controller System Reference Guide344
1 Select Security > Wireless Firewall from the main tree menu.
2 Select the Configuration tab.
3 Click the L2 tab.
4 The L2 tab contains the following information:
Interface Name
Displays the interface associated with the Layer 2 firewall. Available Layer
2 interfaces are ge 1-8 and up1.
ARP Rate
Displays the
Address Resolution Protocol
(ARP) rate. Rates can be
between 1 and 1000000
DHCP Trust
Displays whether or not the DHCP servers configured on the controller are
trusted by the Layer 2 firewall. If DHCP is trusted, DHCP traffic will not
be subjected to the Layer 2 firewall rules. When the DHCP servers is
trusted a green checkmark will be displayed. When the DHCP servers are
not trusted a red “X” will be displayed.
ARP Trust
Displays whether or not the ARP is trusted by the Layer 2 firewall. If ARP
is trusted, ARP traffic will not be subjected to the Layer 2 firewall rules.
When the ARP interface is trusted a green checkmark will be displayed.
When the ARP interface is not trusted a red “X” will be displayed.
Broadcast Storm
Threshold
Displays the Broadcast Storm Threshold for each interface. When the rate
of broadcast packets exceeds the high threshold configured for an
interface, packets are throttled till the rate falls below the configured
rate. Thresholds are configured in terms of packets per second. The
threshold range is 1-1000000 packets per second.
Multicast Storm
Threshold
Displays the Multicast Storm Threshold for each interface. When the rate
of multicast packets exceeds the high threshold configured for an
interface, packets are throttled till the rate falls below the configured
rate. Thresholds are configured in terms of packets per second. The
threshold range is 1-1000000 packets per second.
To Next Page
Loading...