Controller Security
Summit WM3000 Series Controller System Reference Guide350
6 Refer to the Status field for the state of the requests made from applet. This field displays error
messages if something goes wrong in the transaction between the applet and the controller.
7 Click OK to use the changes to the running configuration and close the dialog.
8 Click Cancel to close the dialog without committing updates to the running configuration.
Configuring Denial of Service (DoS) Attack Firewall Rules
To review Denial of Service Attack firewall rules:
1 Select Security > Wireless Firewall from the main tree menu.
2 Click the Configuration tab.
3 Click the DoS Attack tab.
4 The DoS Attack tab contains the following information:
DHCP Trust
Displays whether the Interface is DHCP trusted or not, If the interface is
DHCP trusted then the DHCP Request will forward to the External DHCP
Server otherwise it will not. Always the Internal DHCP servers are trusted
in nature. When ever the interface is DHCP trusted, then it is marked as
GREEN and if it not DHCP trusted it will mark in RED “X”. To enable
DHCP trust, check the box.
ARP Trust
Configure whether or not ARP is trusted by the Layer 2 firewall. If ARP is
trusted, ARP traffic is not subjected to Layer 2 firewall rules. To enable
ARP trust, check the box.
ARP Rate
Enter the ARP threshold.The ARP threshold determines the number of
ARP packets permissible per second. Rates can be between 0 and
1000000
To Next Page
Loading...