Summit WM3000 Series Controller System Reference Guide 387
c Use the None, Domain Name or Host Name radio buttons to select and enter the fully qualified
domain name (FQDN) or host name of the host exchanging identity information.
d Define a SA Lifetime (secs) to define an interval (in seconds) that (when expired) forces a new
association negotiation.
e Define a SA Lifetime (Kb) to time out the security association after the specified traffic (in
kilobytes) has passed through the IPSec tunnel using the security association.
f Use the ACL ID drop-down menu to permit a Crypto Map data flow using the permissions
within the selected ACL.
g Use the PFS drop-down menu to specify a group to require perfect forward secrecy (PFS) in
requests received from the peer.
h Use the Remote Type drop-down menu to specify a remote type (either XAuth or L2TP).
i Use the Mode drop-down menu to specify a mode of Main or Aggressive. Aggressive mode enables
you to configure pre-shared keys as Radius tunnel attributes for IP Security (IPSec) peers.
j Optionally select the SA Per Host checkbox to specify that separate IPSec SAs should be requested
for each source/destination host pair.
k Optionally select the Mode Config checkbox to allow the new Crypto Map to be implemented
using the aggressive mode (if selected from the Mode drop-down menu).
l Refer to the Peers (add choices) field and use the Add and Delete functions as necessary to add or
remove existing peers. For information on adding or modifying peers, see
“Crypto Map Peers” on page 387.
m Refer to the Transform Sets (select one) field to select and assign a transform set for v with Crypto
Map. Again, a transform set represents a combination of security protocols and algorithms.
During the IPSec security association negotiation, peers agree to use a particular transform set for
protecting data flow.
7 Click OK to save the new Crypto Map and display it within the Crypto Map tab.
Crypto Map Peers
To review, revise or add Crypto Map peers:
1 Select Security > IPSec VPN from the main menu tree.
2 Click the Crypto Maps tab and select Peers.
To Next Page
Loading...