Summit WM3000 Series Controller System Reference Guide 423
8 Controller Management
This chapter describes the Management Access main menu items used to configure the controller. This
chapter consists of the following controller management activities:
● Displaying the Management Access Interface on page 423
● Configuring Access Control on page 424
● Configuring SNMP Access on page 426
● Configuring SNMP Traps on page 433
● Configuring SNMP Trap Receivers on page 439
● Configuring Management Users on page 442
Displaying the Management Access Interface
Refer to the main Management Access interface for a high-level overview of the current controller
firmware version and the current controller log output configuration. Use this information to discern
whether a controller firmware upgrade is required (by checking the Website for a newer version) and if
the controller is outputting log data appropriately.
When the controller’s configuration is successfully updated (using the Web UI), the affected screen is closed without
informing the user their change was successful. However, if an error were to occur, the error displays within the
affected screen’s Status field and the screen remains displayed. In the case of file transfer operations, the transfer
screen remains open during the transfer operation and remains open upon completion (with status displayed within
the Status field).
To display the main Management screen:
1 Select Management Access from the main menu tree.
2 Refer to the Current Status field to review the following read-only information:
Firmware In Use
The
Firmware In Use
value displays the software version currently running
on the controller. Use this information to assess whether a firmware
update would improve the controller feature set and functionality.
Log Output
The Log Output value displays the target location for log files output by
the controller.
To Next Page
Loading...