Summit WM3000 Series Controller System Reference Guide 427
1 Select Management Access > SNMP Access > v1/v2 from the main menu tree.
2 Refer to the Community Name and Access Control parameters for the following information:
3 Highlight an existing entry and click the Edit button to modify the properties of an existing SNMP
V1/v2 community and access control definition. For more information, see “Editing an Existing
SNMP v1/v2 Community Name” on page 427.
Editing an Existing SNMP v1/v2 Community Name
The Edit screen allows the user to modify a community name and change its read-only or read/write
designation. Since the community name is required to match the name used within the remote network
management software, it is recommended the name be changed appropriately to match a new naming
(and user) requirement used by the management software.
To modify an existing SNMP v1/v2 Community Name and Access Control setting:
Community Name
Displays the read-only or read-write name used to associate a site-
appropriate name for the community. The name is required to match the
name used within the remote network management software. Click the
Edit
button to modify an existing Community Name.
Access Control
The Access Control field specifies a read-only (R) access or read/write
(RW) access for the community. Read-only access allows a remote device
to retrieve information, while read/write access allows a remote device to
modify settings. Click the
Edit
button to modify an existing Access
Control permission.
To Next Page
Loading...