Summit WM3000 Series Controller System Reference Guide 429
3 Refer to the fields within the V3 screen for the following information:
4 Highlight an existing v3 entry and click the Edit button to modify the password for the Auth
Protocol and Priv Protocol.
For additional information, see “Editing an Existing SNMP v1/v2 Community Name” on page 427
5 Highlight an existing SNMP v3 User Name and click the Enable button to enable the log-in for the
specified user. When selected the status of the user is defined as active.
6 Highlight an existing SNMP v3 User Name and click the Disable button to disable the log-in for the
specified user. When selected the status of the user is defined as inactive.
User Name
Displays a read-only SNMP v3 username of operator or Admin. An
operator typically has an Access Control of read-only and an Admin
typically has an Access Control of read/write.
Access Control
Displays a
read-only
(R) access or
read/write
(RW) access for the v3 user.
Read-only access allows the user (when active) to retrieve information,
while read/write access grants the user modification privileges.
Authentication
Displays the current authorization scheme used by this user for v3 access
to the controller. Click the
Edit
button to modify the password required to
change authentication keys.
Encryption
Displays the current Encryption Standard (DES) protocol the user must
satisfy for SNMP v3 access to the controller. Click the
Edit
button to
modify the password required to change encryption keys.
Status
Displays whether this specific SNMP v3 User Name is active on the
controller. For more information, see “Accessing SNMP v2/v3 Statistics”
on page 431.
To Next Page
Loading...