Summit WM3000 Series Controller System Reference Guide 433
Configuring SNMP Traps
Use the SNMP Trap Configuration screen to enable or disable individual traps or by functional trap
groups. It is also used for modifying the existing threshold conditions values for individual trap
descriptions. Refer to the tabs within the SNMP Trap Configuration screen to conduct the following
configuration activities:
● Enabling Trap Configuration
● Configuring Trap Thresholds
Enabling Trap Configuration
If unsure whether to enable a specific trap, select it and view a brief description that may help your
decision. Use Expand all items to explode each trap category and view all the traps that can be enabled.
Traps can either be enabled by group or as individual traps within each parent category.
To configure SNMP trap definitions:
1 Select Management Access > SNMP Trap Configuration from the main menu tree.
2 Select the Allow Traps to be generated checkbox to enable the selection (and employment) of all the
traps within the screen. Leaving the checkbox unselected means traps must be enabled by category
or individually.
3 Refer to trap categories within the Configuration screen to determine whether traps should be
enabled by group or individually enabled within parent groups.
To Next Page
Loading...