Summit WM3000 Series Controller System Reference Guide 441
Editing SNMP Trap Receivers
Use the Edit screen to modify the trap receiver’s IP Address, Port Number and v2c or v3 designation.
Consider adding a new receiver before editing an existing one or risk overwriting a valid receiver. Edit
existing destination trap receivers as required to suit the various traps enabled and their function in
supporting the controller managed network.
To edit an existing SNMP trap receiver:
1 Select Management Access > SNMP Trap Receivers from the main menu tree.
2 Select (highlight) an existing SNMP trap receiver and click the Edit button.
3 Modify the existing IP Address if it is no longer a valid address.
If it is still a valid IP address, consider clicking the Add button from within the SNMP Trap Receivers
screen to add a new address without overwriting this existing one.
4 Define a Port Number for the trap receiver.
5 Use the Protocol Options drop-down menu to specify the trap receiver as either a SNMP v2c or v3
receiver.
6 Click OK to save and add the changes to the running configuration and close the dialog.
7 Refer to the Status field for the current state of the requests made from applet. This field displays
error messages if something goes wrong in the transaction between the applet and the controller.
8 Click Cancel to close the dialog without committing updates to the running configuration.
Adding SNMP Trap Receivers
The SNMP Add screen is designed to create a new SNMP trap receiver. Use the Add screen to create a
new trap receiver IP Address, Port Number and v2c or v3 designation. Add new destination trap
receivers as required to suit the various traps enabled and their function in supporting the controller
managed network.
To add a new SNMP trap receiver:
1 Select Management Access > SNMP Trap Receivers from the main menu tree.
2 Click the Add button at the bottom of the screen.
To Next Page
Loading...