Summit WM3000 Series Controller System Reference Guide 475
6 Click Cancel to return back to the Configuration tab without implementing changes.
Adding a New Ping Test
If the attributes of an existing ping test do not satisfy the requirements of a new connection test, and
you do not want to modify an existing test, a new test can be created and added to the list of existing
ping tests displayed within the Configuration tab.
To create a new ping test and add it to the list of existing tests:
1 Select Diagnostics > Ping from the main menu.
2 Click the Add button at the bottom of the Configuration tab.
3 Enter the following information to define the properties of the new ping test:
Test Name
Enter a short name for the ping test to describe either the target
destination of the ping packet or the ping test’s expected result. Use the
name provided in combination with the ping test description to convey
the overall function of the test.
Description
Ensure the description is representative of the test, as this is the
description displaying within the Configuration tab.
Destination IP
Enter the IP address of the target device. This is the numeric (non DNS
address) destination for the device transmitted the ping packets.
No. of Probes
Define the number of ping packets transmitted to the target device. This
value represents the number of packets transmitted to the target IP
address to discern the round trip time between the controller and its
connected device.
To Next Page
Loading...