ETHERNET
RIGHT LEFT
12V @ 2A
ILLUMINATOR
ONLY
EyeLink Ethernet
Quick Start Guide
2
Camera Connecon
3
4
Oponal Response Box Connecon
Parallel Port
USB Port
5
Display PC
rnet
1
Basic PC Setup
Keep the Laptop Host PC (included) powered off for now, but connect its power supply and USB Ethernet adapter. Set up the basic components of the Display PC as you would any other computer.
The Display PC can be any modern Windows (XP, Vista, or 7), Mac OS X (10.6.8 or later), or Linux PC with Ethernet, and may have been oponally acquired from SR Research.
ETHERNET
RIGHT LEFT
12V @ 2A
ILLUMINATOR
ONLY
Display PC
ETHERNET
RIGHT LEFT
ILLUMINATOR
ONLY
EyeLink 1000 Plus
with Desktop Mount
Surge Protector
Using the black Ethernet cable, connect the
Ethernet port that is built-in to the Host PC to the
Ethernet port on the EyeLink 1000 Plus camera.
Host PC to Display PC Connecon
Using the blue Ethernet cable, connect the Host PC
USB Ethernet adapter (labeled “Display PC Ethernet”)
to an Ethernet port on your Display PC. Configure
that port with the following stac IP address:
IP Address: 100.1.1.2
Subnet Mask: 255.255.255.0
Laptop Host PC with Desktop Mount
Version 1.00W
USB Ports
USB Ports
Connect the oponal response box (not
included by default) to the appropriate port
on the Host PC.
Test that the Setup is Working
Turn on the Host PC to verify that
the Host Applicaon starts. Once the
Host PC is up and running you should
see the Camera Setup screen.
e.g., VPixx Series
Microso Xbox 360 Controller
or
Logitech Gamepad F310
To exit to the File Manager from the Host Applicaon, press Ctrl-Alt-Q (or click Offline and
then Exit EyeLink). The File Manager interface is Illustrated below. You can use the buons
highlighted below to start the Host PC Applicaon or shut down the Host PC.
Starts Host Applicaon
Shuts down Host PC
Connued
on back
Laptop Host PC