EasyManuals Logo

EZ-ACCESS TITAN Assembly Manual

EZ-ACCESS TITAN
77 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
Page 76 of 77
8. MAINTENANCE
8.1. PERIODIC MAINTENANCE
8.1.1. Caution should be used at all times. Proper maintenance and upkeep to the ramp
system is vital.
8.1.2. Periodically check the ramp for damage and tighten any loose fasteners to ensure
safety.
8.1.3. At all times, keep the system clear of dirt, leaves, and other debris that may
accumulate on the surface. Simply sweeping the surface or using a garden hose will
usually suffice, but, if needed, a damp cloth or soft brush with soap and water can be
used (avoid use of alkaline detergents).
8.1.4. If system surface is covered with ice and/or snow, DO NOT USE until accumulation is
removed and the tread surface swept clean. Please refer to ‘DEICING SECTION’ of this
for more information.
8.1.5. If any part of the ramp is damaged or loose, DO NOT USE UNTIL REPAIRS ARE MADE
BY A CERTIFIED INSTALLER OR OTHER QUALIFIED PERSON.
9. DEICING
For the safety of all users, it is important to keep your system clear of snow, ice, and other debris.
Always follow the deicing agent manufacturer’s directions.
EZ ACCESS will not be held responsible for any injuries or damages that arise from the information
provided. ALWAYS check with the deicing product’s manufacturer or your local supplier to determine
which method is best for your situation.
After the snow and/or ice threat has cleared, be sure to clean the tread surface with mild soap and
water (avoid alkaline detergents) to remove deicing residue.
Sodium Chloride (salt) and Calcium Chloride are particularly damaging to newly poured
concrete. In addition, these chemicals should not be applied to brick and stone surfaces.
While care has been taken to ensure that the table below is accurate, the information shown
is not all-inclusive. Manufacturers of deicing products may make changes to their products as
well as recommended functions and usage requirements. The deicing method you choose
should be researched with your deicer supplier so you can determine which method is best for
your situation.
The information below is taken from Fact Sheet 707, Cooperative Extension Service, University
of Maryland at College Park, University of Maryland Eastern Shore and was up-to-date at the
time of this manual’s publication.
PRODUCT
MIN. WORKING
TEMP (
o
F)
SPEED OF ACTION
DAMAGES
CONCRETE AND
METALS?
HARMFUL TO
PLANTS?
MAGNESIUM
CHLORIDE
-13
VERY FAST
NO
MODERATE
CALCIUM CHLORIDE
5
FAST
YES
YES
SODIUM CHLORIDE
(SALT)
18
MODERATE
YES
YES
POTASSIUM CHLORIDE
25
SLOW
OK ON OLD
CONCRETE
MODERATE
CALCIUM MAGNESIUM
ACETATE (CMA)
25
SLOW
NO
NO

Table of Contents

Other manuals for EZ-ACCESS TITAN

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EZ-ACCESS TITAN and is the answer not in the manual?

EZ-ACCESS TITAN Specifications

General IconGeneral
BrandEZ-ACCESS
ModelTITAN
CategoryLifting Systems
LanguageEnglish

Related product manuals