1
Setup
Step 1 Power-on
Plug the power cable into the camera, and then plug the power adapter into an outlet as shown
in the figure below.
Turn on the camera and let it power up. The camera will completely rotate side-to-side
and tilt up-and-down once.
LED Indicator Status
Solid Red: Camera is starting up.
Slowly Flashing Red: Wi-Fi connection has failed.
Fastly Flashing Red: Device exception (e.g.
MicroSD card error).
Solid Blue: Video is being viewed or played back
in EZVIZ App.
Flastly Flashing Blue: Camera is ready for the Wi-
Fi connection
Slowly Flashing Blue: Camera is running properly.
Power Outlet
Power Cable
Power Interface
To Next Page
Loading...
Need help?
General
