To Next PageTo Next Page
Need help?Do you have a question about the F.P.Z. SCL K-MS MOR Series and is the answer not in the manual?
General| Series | MOR |
|---|---|
| Frequency | 50/60 Hz |
| Housing Material | Aluminum Alloy |
| Impeller Material | Aluminum Alloy |
| Protection Class | IP55 |
| Insulation Class | F |
Specifies operating conditions, temperature limits, and environmental requirements for the blowers.
Provides guidelines for safe and effective storage and transportation of the units.
Details installation procedures, including environmental and mounting considerations for the units.
Steps for putting the unit into operation, including pressure checks and safety valve verification.
Guidance on managing driving pressure and flow, including bypass valve usage.
Details routine maintenance, filter cleaning, and periodic inspections for unit longevity.
Diagram illustrating a standard pressure service installation setup.
Diagram showing two units installed in parallel for pressure service.
Diagram illustrating two units installed in series for pressure service.
Diagram for a standard vacuum service installation setup.
Diagram showing two units in parallel for vacuum service.
Lists and identifies various accessories available for installation.
Step-by-step guide for cleaning the internal components of the blower.
Procedure for replacing the sound-absorbing panels within the unit.
Instructions for mounting the 90° manifold kit for flexible silencer positioning.
Troubleshooting steps for when the unit fails to start, covering wiring and power issues.
Diagnosing and resolving issues with low or no airflow, like impeller or filter problems.
Addressing problems where the unit's power consumption is too high, checking wiring and supply.
Troubleshooting high delivery air temperature due to clogged filters or operating conditions.
Identifying causes of excessive noise, such as impeller scraping or external factors.
Resolving abnormal vibrations caused by impeller damage, deposits, or improper mounting.
