FAAC 950 BM - Page 25

25
FAAC MODEL 950 BM Door Operator
11.2. 2 LEAVES
The “2 LEAVES” function makes it possible to manage two opposing
doors with a synchronised movement and preset delay angles (these
cannotbemodied).
The leaf controlled by the master automated system (see g. 30)
isthersttostarttheopeningmovementand,whenithasreached
the opening angle preset for leaf delay, the slave leaf begins its
movement too.
Likewise, when closing, the master begins to move only when the
slave has reached the closing angle preset for leaf delay.
If one of the automated systems detects an obstacle, the movement
of both leaves is immediately reversed.
The partial opening function enables control of total opening of the
master only.
The operating functions must be set on the master automated system
only (or on the KP-Controller if connected).
•Makethe connectionsbetweenthe950I/Ocontrolunitofthe
twoautomatedsystemsasshowning.31.
•Connectallsensorsandpulsegeneratorstothemasteronly.
•Programthefollowingfunctions(seeadvancedprogramming):
-“2LEAVES”activeonbothdoors;
- Select the “MASTER” option for the door due to begin the ope-
ningmovementrst,andselect“SLAVE”fortheotherdoor.
- Set the same motion parameters on the two automated
systems;
- If you wish to disconnect the KP-Controller from the slave
door,youhavetosetfunction“KEEPSETTINGS”toON;
Master Slave
Slave Master
Fig. 30
Fig. 31
(800) 878-7829
www.FastGateOpeners.com