FAAC A1400 AIR RDT - 10. Glass Leaf Installation

A1400 AIR RDT 40 532119 04 - Rev. C
L/3L/3 L/3
L
11
11
Ø 7 mm
53
3 4
1 1
3 4
5
11
9
4
3
7
7
8
9
66
10
7
8
11
Nm
8
6
2.5
Nm
2
10 mm
8 mm
6 mm

Translation of the original instructions
ENGLISH
10. INSTALL GLASS LEAVES
RISKS
PERSONAL PROTECTIVE EQUIPMENT
REQUIRED TOOLS
Ø 5-6.5 mm
45° M6 8 6-8
For manual lifting, arrange for 1 person every 20 kg to be lifted.
!
Comply with the glass thickness =
10-11 mm.
10-11 mm.
1. The glass must be drilled as shown 53-

.
2. Insert a bush in each hole of the glass 53-

.
3. Make 2 holes on the profiles of the gripper
53-

-

.
.
4. Cut 2 pieces of glass beading with the length equal to L.
5. Drill holes in the beadings in correspondence to the holes in the
glass 53-

.
6.
6.
Insert
Insert the 2 beadings in the profiles 53-

.
7. Clean the glass, insert the gripper.
!
Ensure the beading is in its housing.
8. Assemble the gripper as follows: insert in the 2 plates

ele-
ments

and

.
9. Screw the 2 grub screws 53-

.
10.

must be aligned with the fixing holes on the carriage 54-

11. Insert 2 galvanised countersunk head screws in the holes 53-

.
!
The glass must be fully inserted until it touches the clamps on its
upper profile. If the grip of the clamp on the glass is not correct, the
glass might fall. The two clamp profiles must be aligned.
Adjust the position of the two plates on the leaf.
- Adhere to the dimensions set out in diagrams 104 or 105
and :
- 108 - 106 for RIGHT single leaf automations
- 109- 107 for LEFT single leaf automations
- 110 - 109 for DOUBLE leaf automations
For manual lifting, arrange for 1 person every 20 kg to be lifted.

Ø 8.5 mm

bush Ø internal 6 mm
Ø external 8 mm

Ø 6.5 mm with 45° flaring

Ø 5.0 mm with M6 tapping

Ø 7.0 mm

2 x M8

2 x M6 x 25 UNI 5933