FAAC A1400 AIR RDT - Advanced Programming Parameters (Continued); J22 Outputs and Input Status Configuration

A1400 AIR RDT 67 532119 04 - Rev. C
Translation of the original instructions
ENGLISH
(
*
)
value
EP
EP:
programming with SDK EVO offers a wider number of options compared to the board. The board does not display the values it does not have and shows them all as EP (External
Program). Programming with the board lets you overwrite values EP, choosing an available value with +/
-
.
ADVANCED Function Default
O2
O2
CONFIGURABLE OUTPUT OUT2 (J22)
NO Output
(
**
)
(
**
)
Programmable as NC with SDK EVO
00
00 = not enabled
01
01 = GONG
02
02 = BOARD ERROR/FAULT
03
03 = BATTERY Operation
04
04 = EMERGENCY active
05
05 = TEST on the configured safety devices
on inputs I1, I2, I3, I4.
06
06 = door NOT CLOSED
07
07 = door OPEN
08
08 = door in motion
09
09 = light (activated for 60 s) (activation time can be
changed with SDK EVO)
10
10 = INTRUSION in progress
11
11= At least one Safety in Closing On
12
12= At least one Safety in Closing On
or one Safety in Opening On
06
06
In
In
Inputs status
The display segments correspond, each one has an input
and indicating whether it is active or not:
1
2
7
3
11
12
10
14
6
4
8
9
13
5
1 = S1 input
2 = S2 input
3 = manual release input
4 = S3 input
5 = Emergency 1 input
6 = S4 input
7 = I input
8 = I1 input
9 = I2 input
10 = FSW input
11 = I3 input
12 = I4 input
13 = Emergency 2 input
14 = E input

Segments 3 and 7 switch on for the BI-STABLE
motor block, whilst only segment 3 switch on
for the MONOSTABLE motor block
ADVANCED Function Default
St
St
EXIT PROGRAMMING
It lets you exit programming, and decide whether to save or
not the modifications made.
Y
Y = save (only if there are NO configuration errors)
no
no = do not save
Press F to confirm. After exit, the display shows automation
status.
Y
Y