FAAC A1400 AIR - Motor Block Alignment and Cable Guides; 11.10 Aligning the XB LOCK Motor Block; 11.11 Installing the XM Lock Motor Block; 11.12 Mounting the Cable Gland Guides

A1400 AIR 51 532129 04 - Rev.B
70
1
2
3
2
1
2
1
3
4
4
71
72
5
Translation of the original instructions
ENGLISH
11.10 ALIGNING THE XB LOCK MOTOR BLOCK
The motor block must be aligned with the motor.
1. Apply an adhesive strip at the top of the profile 70-

.
2. Insert the adjustment screw onto the motor block bracket with the
head facing upwards in contact with strip 70-

.
3. Adjust it using the nut and lock nut 70-

.
11.12 MOUNTING THE CABLE GLAND GUIDES
!
The guides prevent interference between cables and moving parts.
Install the electric cable guides inside the support profile 72-

and

).
11.11 INSTALLING THE XM LOCK MOTOR BLOCK
1. Install the motor block by engaging the retaining hook

in the
slot

of the motor block 71.
2. Check that the motor block is properly engaged 71-

.
3. Adjust the monitoring micro switch support and check
the switching of the micro switch contact 71-

4. After making sure that it is, tighten screw 71-

.