FAAC TM XTT 433 R - Page 42

18
0
00
S
ENGLISH
11 8se WKe or Ne\ Wo seleFW WKe desired dail\ eYeQW
(1-5 .
OFF 1 = event 1 - OFF 2 = event 2 -OFF 3 = event 3
- OFF 4 = event 4 - OFF 5 = event 5
12 Press WKe
Ne\ Wo eQaEle (On or disaEle (OFF WKe
ForrespoQdiQJ eYeQW aQd FoQIirP E\ pressiQJ
.
13 TKe WiPe aW ZKiFK WKe preYioXsl\ seleFWed eYeQW Zill
Ee perIorPed Zill Ee displa\ed.
14 8se WKe
or Ne\ Wo seW WKe FoPPaQd WriJJer
WiPe aQd FoQIirP E\ pressiQJ
.
15 TKe PiQXWes oI WKe preYioXsl\ seleFWed KoXr Zill Ee
displa\ed. Press
Wo FoQIirP.
16 TKe PoYePeQW \oX ZisK Wo perIorP Zill Ee
displa\ed.
1 8se WKe
or Ne\ Wo seW WKe PoYePeQW WKaW
\oX ZaQW WKe roller sKXWWer Wo perIorP aQd FoQIirP E\
pressiQJ
;
PoYe Xp
preIerred posiWioQ
PoYe doZQ.
18 TKe Zord “donE” µ is displa\ed Wo FoQIirP WKaW
proJraPPiQJ Kas EeeQ FoPpleWed.
19 To add oWKer eYeQWs, repeaW WKe proFedXre sWarWiQJ
IroP poiQW 9 II \oX ZisK Wo seleFW aQoWKer FKaQQel iQ
order Wo seW eYeQWs oQ i
W, seleFW e[iW (see paJe 19.
20 To e[iW WKe proJraPPiQJ PeQX ZaiW 60 seFoQds or
press
Ior 5 seFoQds
8 ´ Ch µ is displa\ed Wo leW \oX choose the channels
oQ ZKiFK \oX FaQ seW WKe aFWioQs Ior WKe preYioXsl\
seleFWed da\s
9 8se WKe
or Ne\ Wo seleFW WKe desired FKaQQel
oQ ZKiFK \oX ZisK Wo aFWiYaWe WKe eYeQW aQd FoQIirP E\
pressiQJ
.
10 A ZiQdoZ Zill Ee displa\ed Wo leW \oX PaQaJe WKe
dail\ eYeQWs. e.J
OFF 1
Events are factory set on OFF.
ON / OFF lets you program a certain event and enable/disable it at any time, without having to
delete and re-program the TM XTT 433 R timer.
After having programmed the TM XTT 433 R timer, the settings made will be operative only when
the event is enabled (ON); if the event is disabled (OFF) the settings will not be active but will however remain
memorised in the corresponding setting.