To Next PageTo Next Page
Need help?Do you have a question about the Fabco Power HYDRO ARC-S-6500 JSBC and is the answer not in the manual?
General| Duty Cycle | 60% |
|---|---|
| Efficiency | 85% |
| Protection Class | IP23 |
| Input Phase | 3-Phase |
| Output Current | 650A |
| Welding Process | TIG, MIG |
| Output Current Range | 650A |
Warning regarding customer-supplied flow regulators and potential over-speed damage not covered by warranty.
Steps for operating the welder/generator including connecting leads, setting switches, and starting the system.
Important safety advice regarding cable connections and switch operations during welding.
Detailed steps for welding, battery charging (12V/24V), and jumpstarting vehicles.
Procedures for jumpstarting 24V batteries and connecting wire feeders.
Diagnosing and resolving issues when the welder has no AC or weld power output.
Troubleshooting no output on weld or AC receptacles, potentially due to residual magnetism.
Diagnosing lack of welding power while AC output is functional, caused by transformer, stator, or bridge issues.
Resolving no AC output issues while weld output is functional, checking AC windings and receptacle wiring.
Identifying causes for low welding amperage, related to excitation bridge, fine control, or thermal trip.
Addressing intermittent operation due to duty cycle, high ambient temperatures, or blocked cooling circuits.
