5
4. Install the pedals. Note the markings on the pedal screws and on the crank
arms. Stamp with "L" is the left pedal, stamp with "R" is the right pedal, the
right pedal is installed on the side of the sprocket. NOTE: The left pedal is
tightened to the left and the right pedal is tightened to the right.
5. Install the bell. Loosen the bell screw, put the bell in place and tighten the screw.
6. Adjust the headlight. Adjust the headlight position and tighten the screw.
To Next Page
Loading...
