Fagor 3FLV-1455R - Additional Information on the Temperature; Lighting; Replace the Light Bulb

54
Additional information on the temperature
• The temperature inside the appliance is inuenced by many factors. How you
set the temperature control dial depends on the ambient temperature, sun ex-
posure, how often you open the door and the amount of food stored. The middle
setting of the dial is most optimal in most cases.
• Do not put food into the fridge freezer before it has reached its operating temper-
ature, which takes minimum 4 hours.
• Do not change the temperature settings due to the change in the season of the
year. The ambient temperature increase will be detected by the sensor and the
compressor will be switched on automatically for a longer period of time in order
to maintain the temperature set inside the chambers.
• The slight changes in temperature are perfectly normal and may occur, for in-
stance during the storage of great quantities of fresh products in the fridge, or
when the door is open for a longer period of time. This will not aect the condition
of the stored foodstu, and the temperature will quickly return to its set value.
LIGHTING
This section applies to units factory equipped with incandescent lightbulb and se-
lected appliances equipped with LED lighting with E14 thread.
Replace the light bulb
• Set the knob to “OFF”, then unplug the appliance.
• Remove the bulb cover (Fig. 18).
• Replace the bulb with one having identical parameters as the factory installed
bulb (E14 thread, 220-240V, maximum dimensions: 26 mm diameter, 55 mm
length).
• Replace the bulb cover.
• Bulbs of a higher or lower power should not be used, only use bulbs of the spec-
ication given above.
Note:
• The light bulb must not be used for room illumination.
• If Figure 18 is not shown in this manual, light source can only be replaced by a
qualied service technician.