Fagor 3IF-ZONE96C4S - Page 59

59
OPERATION
The Stop’n go function can be activated for a maximum of 10 minutes. If the
Stop’n go function is not deactivated within this time, the appliance will switch
itselfo.
If the control was turned o accidentally by touching the on/o sensor (1),
Stop'n go function will quickly restore the settings. To restore the settings after the appliance
has been switched o using the on/o sensor (1), touch the on/o sensor (1) again within 6
seconds. "0" will be shown on all cooking zone displays (3) and the LED indicator light will
start ashing above the Stop’n go function sensor (10). Then, during the next 6 seconds, touch
the Stop’n go function sensor (10). Cooking zone displays (3) will show the heat setting that
was previously set before the appliance was accidentally switched o.
Bridge function
The Bridge function allows pairing of two cooking zones into a single combined cooking zone.
The Bridge function is very convenient, especially when cooking in large pots such as a bak-
ing pan.
Bridge function may be set for two cooking zones vertically. To set the Bridge function simply
simultaneously press 2 sensors (2) located directly under the cooking zones.
When you press the two sensors, the display will show the Bridge function symbols (13).
Bridge function is controlled with (2) sensor, above which the display (3) lights up.
Now both cooking zones can be controlled at the same time.
To deactivate the Bridge function, simultaneously touch the same two sensors (3), which
were used to activate the Bridge function. The respective cooking zone displays will show "0".
Now both cooking zones can be controlled independently.
Stop’n go function "II"
Stop’n go function acts like a pause. The Stop’n go function simultaneously suspends opera-
tion of all cooking zones and then resumes at the heat settings that were previously set.
In order to activate the Stop’n go function, at least one cooking zone must be in use.
Next, touch the Stop’n go function sensor (10). "II" will be shown on all cooking zone displays
(3) and LED indicator light will light up above the Stop’n go function touch sensor (10).
To disable the Stop'n go function, touch (10) sensor again, indicator light goes out, and the
rear right cooking zone display will show the hob unlock method. Touch (2) sensor in position
0 and slide your nger on the sensor to the right to position 9.