34
CONTROL ELEMENTS
Control elements - one and two zones
The control panel is shown in Figure 5. It is also shown below:
Single zone
Two zones
Press to turn on the appliance. Press and hold the button for 3 seconds to turn o
the appliance.
Note: It will take about 3 seconds for all LED displays to turn o.**
Press to turn the interior LED lighting on/o. Interior lighting is not controlled by
opening and closing the door.
To reduce energy consumption, LED lighting will turn o automatically after 3-4 sec-
onds.*
If you want the interior lighting to remain on, press and hold for 5 seconds — the
display will show “LP”. After 4 seconds, the display will show the temperature again
and the light will be on until it is switched o again. Press and hold for 5 seconds
to set the light is to switch o automatically after few seconds (recommended), The
display will show “LF”. After 4 seconds, the display will show the temperature again
and the light will be on for only 3-4 seconds.
Set the temperature — single-zone refrigerator
Press to increase the temperature in the chamber by 1°C*.
Press to decrease the temperature in the chamber by 1°C*
• The range of temperature that can be set varies between 5°C and 20°C.
• The optimal temperature for wine storage is 12°C.
• To check the current temperature inside the chamber, press and hold or for 3
seconds and the display will show the current temperature. After 5 seconds, the
To Next Page
Loading...
