15
Tip
In all circumstances, if your efforts are not sufficient, contact the After-Sales Service
Department without delay.
If you have a doubt about the correct functioning of your oven, this does not
necessarily mean that there is a malfunction.
In any event, check the following items:
5 / WHAT TO DO IF YOUR OVEN MALFUNCTIONS
Warning
- Repairs to your appliance should only be performed by professionals. Non-standard repairs
may be a source of danger for the user.
99645831 04/08
EN
YOU OBSERVE
THAT…
POSSIBLE
CAUSES
WHAT SHOULD YOU DO?
The oven is not
heating.
- The oven is not connected to
the power supply.
- Your fuse is out of order.
- The selected temperature is
too low.
➡ Plug in your oven.
➡ Replace the fuse in your
electrical set-up and check its
capacity (see table, section
“cable/fuse cross-section”).
➡ Increase the selected
temperature.
The oven light is not
working.
- The light is out of order.
- The oven is not connected or
the fuse is not working.
➡ Change the bulb.
➡ Plug in your oven or change the
fuse.
The pyrolysis cleaning
cycle does not begin.
- The door is not properly
closed.
- The locking system is
defective.
➡ Check that the door is locked.
➡ Call the After-Sales Service
Department.
Your oven starts
beeping.
- During cooking.
- At the end of a cooking
cycle.
➡ The recommended temperature
of your choice has been reached.
➡ Your programmed cooking
cycle is finished.
The cooling fan
continues to operate
after the oven stops.
- The fan should work for a
maximum of one hour after
cooking, or when the oven
temperature is greater than
125°C.
- If it does not stop after 1 hour
➡ Open the oven door to
accelerate the cooling down of the
oven
➡ Call the After-Sales Service
Department.
To Next Page
Loading...
