Fagor 8035-T - Page 115

 Installation manual
CNC 8035
MACHINE PARAMETERS
General machine parameters
4.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·115·
LCOMPTYP (P191):
It may be used to set whether the longitudinal axis will be maintained or changed when changing
the work plane(G17, G18 or G19).
This parameter has 16 bits counted from right to left.
Bit 0 of g.m.p. LCOMPTYP (P191):
Value Meaning
0 The longitudinal axis changes when changing planes.
1 The longitudinal axis does not change when changing planes.
Default value: 0
bit
15
14 13 12 11 10 9 8 7 6 5 4 3 2 1 0