Fagor 8035-T - Page 160

 Installation manual
CNC 8035
4.
MACHINE PARAMETERS
Spindle parameters
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·160·
OPLDECTI (P86)
It indicates the duration of the spindle deceleration ramp in open loop.
The s.m.p. OPLDECTI (P86) works on the first and second spindle.
If OPLDECTI (P86) = 0, s.m.p. OPLACETI (P45) will be applied both for acceleration and
deceleration.
If s.m.p. JERKLIM (P80) other than 0 and s.m.p. OPLDECTI (P86) other than 0, parameter JERKLIM
will be applied for deceleration. In this case, the deceleration dynamics will be of the square-sine
type.
Possible values
Integers between 0 and 65535 ms.
Default value: 0.