Fagor 8035-T - Page 164

 Installation manual
CNC 8035
4.
MACHINE PARAMETERS
Serial line parameters
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·164·
PROTOCOL (P4)
Indicates the type of communications protocol to be used.
PWONDNC (P5)
Indicates whether the DNC feature will be active on power-up or not.
DNCDEBUG (P6)
Indicates whether the debugging feature for DNC communications is active or not.
It is advisable to use this safety feature in all DNC communications. It could be deactivated in the
debugging process.
ABORTCHR (P7)
Indicates the character used to abort communications with general peripheral device.
EOLCHR (P8)
Indicates the character used to indicate "end of line" when communicating with general peripheral
device.
Value Meaning
0 Communications protocol for general device.
1 DNC communications protocol.
2 Communications protocol for Fagor floppy disk unit.
Default value: 1 (DNC)
Value Meaning
NO Not active on power-up.
YES Active on power-up
Default value: NO
Value Meaning
NO Debug NOT active. Communication aborted.
YES Debug active. Communication not aborted.
Default value: NO
Value Meaning
0CAN
1EOT
Default value: 0
Value Meaning
0LF
1CR
2LF-CR
3 CR-LF
Default value: 0