Installation manual
CNC 8035
4.
MACHINE PARAMETERS
Ethernet parameters
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·168·
ETHEINLE (P31)
Not being used.
CNC connection in an Ethernet network.
Connection using Windows
®
95 or 98.
Connection with a shared CNC without password
At the Web browser (e.g. IExplorer) or from the file explorer (only on Windows 98), write in the
command line the CNC's IP address.
For example: ftp://10.0.7.224
Connection with a shared CNC with password
At the Web browser (e.g. IExplorer) or from the file explorer (only on Windows 98), write in the
command line the user name, the password and the CNC's IP address. The user name is always
"cnc".
For example: ftp://cnc:password@10.0.17.62
Assign a name to the IP address
The IP address may be assigned a name for easier identification. This operation is carried out at
the PC and there are two different ways to do it.
• Editing the file "c:\windows\hosts". This file may be modified with any text editor.
In the file, add a line containing the CNC'S IP address and the name to identify it with. For
example:
On the Web browser or from the file explorer (only on Windows 98), write the defined name in
the command line.
For example (CNC without password): ftp://CNC_01.
For example (CNC with password): ftp://cnc:password@MILL_MACH_01
• Through the "Favorites" menu of the Web browser.
In the Web explorer, write the IP address in the command line. After accessing the site, select
the "Favorites" option on the menu > add to favorites and assign a name to that IP address. This
way, it is possible to access the CNC by selecting the assigned name on the "Favorites" menu.
10.0.7.40 CNC_1
10.1.6.25 MILL_MACH_01
On the Iexplorer browser, it is called "Favorites". This name may vary depending on
the Web browser being used.
To Next Page
Loading...
