Installation manual
CNC 8035
MACHINE PARAMETERS
PLC Parameters
4.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·171·
PLCMEM (P27)
Not being used.
SRR700 (P28) . . . SRR739 (P67)
Not being used.
SWR800 (P68) . . . SWR819 (P87)
Not being used.
OCANSPE (P88) IOCAGEN (P89)
Not being used.
IOCANID1 (P90) IOCANID2 (P91) IOCANID3 (P92) IOCANID4 (P93)
Not being used.
ICAN1 (P94) OCAN1 (P95) ICAN2 (P96) OCAN2 (P97)
CAN3 (P98) OCAN3 (P99) ICAN4 (P100) OCAN4 (P101)
Not being used.
NUICAN1 (P102) NUOCAN1 (P103) NUICAN2 (P104)
NUOCAN2 (P105) NUICAN3 (P106) NUOCAN3 (P107)
NUICAN4 (P108) NUOCAN4 (P109)
Not being used.
IANA5V (P130)
Not being used.
NUILO1 (P131) NUOLO1 (P132)
These PLC machine parameters may be used to redefine the numbering of the inputs/outputs of
the local expansion module without having to modify the PLC program.
The CPU of the 8035 CNC may have digital 16I/8O and optionally a single local digital expansion
of 24I/16O.
The inputs/outputs that do not belong to the expansion module are numbered starting from I1 and
O1 and cannot be set by parameters.
IMPORTANT:The numbering of both the first local input and the first local output of the expansion
module must be a multiple of 8 plus 1 (1+ 8n).
Same as with sinewave feedback, number of axes and the user channel active, the
PLC demands calculation time from the system CPU.
The more time the CPU dedicates to the PLC, the greater the sampling time will be,
g.m.p. LOOPTIME (P72).
Value Meaning
NUILO1 Numbering of the first input of the expansion module with inputs/outputs (I/
O).
NUOLO1 Numbering of the first output of the expansion module with inputs/outputs
(I/O).
To Next Page
Loading...
