Installation manual
CNC 8035
MACHINE PARAMETERS
Tables
4.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·177·
4.9.3 Cross compensation parameter table
To enable this table, set g.m.p.:
MOVAXIS (P32) COMPAXIS (P33) NPCROSS (P31)
Parameter MOVAXIS indicates the axis that moves and COMPAXIS the axis affected by the
movement of the "movaxis" (to be compensated) and NPCROSS indicates the number of points
in the table.
The table must indicate the amount of error to be compensated in specific positions of the moving
axis.
The position is defined in home coordinates (referred to machine reference zero). Depending on
g.m.p. TYPCROSS (P135), the CNC will take into account either the theoretical or real (actual)
coordinates.
Possible values for the position and error fields:
When defining the profile points in the table, the following requirements must be met:
• The axis points must be in sequential order starting from the most negative (least positive) point
to be compensated.
• For those points outside the compensation zone, the CNC will apply the compensation value
corresponding to the table point closest to them.
When both leadscrew and cross compensations are applied on the same axis, the CNC will apply
the sum of the two.
Possible values
Within ±99999.9999 mm or ±3937.00787 inches.
To Next Page
Loading...
