Installation manual
CNC 8035
5.
CONCEPTS
Axes and coordinate systems
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·186·
Programming and movements
Coordinates display
If the incline axis is active, the coordinates displayed will be those of the Cartesian system; otherwise,
it will display the coordinates of the real axes.
Movement programming
The inclined plane is activated from the part-program (function G46). Two kinds of movements may
be executed.
• The movements are programmed in the Cartesian system and are transformed into movements
on the real axes.
• Movement along the incline axis, but programming the coordinate in the Cartesian system. While
this mode is active, in the motion block only the coordinate of the incline axis must be
programmed.
Jog movements
PLC mark "MACHMOVE" determines how the manual movements with handwheels or with the
keyboard will be carried out.
MACHMOVE = 0 Movements on the Cartesian axes.
MACHMOVE = 1 Movements on the incline axes of the machines.
Home search
While searching home, the movements are carried out on the incline axes of the machine. The incline
axis is deactivated when searching home on any axis that is part of the incline axis configuration.
To Next Page
Loading...
