CNC 8035
·21·
Version history (T)
Software V12.01 August 2005
Software V12.11 February 2006
Software V12.13 June 2006
Software V12.14 August 2006
Software V12.18 June 2007
List of features Manual
The CNC supports Memkey Card + Compact Flash or KeyCF. OPT
File explorer to show the contents of the storage devices. INST / OPT
Loading the version from the Memkey card o from the hard disk. OPT
New way to search home that may be selected through g.m.p. I0TYPE=3. INST
Improved block search. Switching from simulation to execution. INST / OPT
New repositioning mode that is activated by setting g.m.p. REPOSTY=1. INST/PRG/OPT
Square-sine ramps on open-loop spindle. INST
Numbering of the local inputs/outputs of the expansion modules using plc machine parameters. INST
Default value of axis and spindle machine parameter ACFGAIN = YES. INST
Setting axis parameters FFGAIN and FFGAIN2 with two decimals. INST
Up to 400 (DEF) symbols now available at the PLC. INST
New HTOR variable that indicates the tool radius being used by the CNC. INST / PRG
Spindle override in the whole threading cycle at 100%. PRG
List of features Manual
Handwheel feedback taken to a free feedback connector. INST
New variables: RIP, GGSE, GGSF, GGSG, GGSH, GGSI, GGSJ, GGSK, GGSL, GGSM, PRGSP
and PRBMOD
INST
G04 K0. Block preparation interruption and coordinate update. PRG
List of features Manual
Smooth stop when homing the axes, it may be selected with a.m.p. I0TYPE. INST
List of features Manual
Selecting the additive handwheel as handwheel associated with the axis. INST
List of features Manual
Copy and execute programs on Hard Disk (KeyCF) OPT
To Next Page
Loading...
