Installation manual
CNC 8035
CONCEPTS
Reference systems
5.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·219·
5.6.4 Axis travel limits (software limits)
Once all the axes have been referenced, their software limits must be measured and set.
This operation must be carried out one axis at a time and it could be done as follows:
• Move the axis in the positive direction towards the end of the axis travel stopping at a safe
distance from the mechanical end-of-travel stop.
• Assign the coordinate shown by the CNC for that point to a.m.p. LIMIT+ (P5).
• Repeat these steps in the negative direction assigning the resulting coordinate to a.m.p. LIMIT-
(P6).
• Once both travel limits have been set for all the axes, press SHIFT + RESET or turn the CNC
OFF and back ON in order for these new values to be assumed by the CNC.
To Next Page
Loading...
