CNC 8035
·22·
Version history (T)
Software V14.01x December 2006
Software V16.01 May 2007
Software V16.11x March 2008
Software V16.12 May 2008
List of features Manual
Display of PLC or CNC messages in Russian and Chinese. INST
New FAGOR filters. INST
Leadscrew backlash compensation. Compensation peak cutting criterion. INST
Home search on Gantry axes (managing two home switches). INST
Automatic spindle homing with the first M3/M4. OPT
Allow two "switched" axes to have different gear ratios. INST
Look-Ahead. Angle below which, it machines in square corner mode. PRG
Teach-in. Execution of the edited block. OPT
Improvements to the oscilloscope and direct access from jog and execution modes. OPT
Editing on hard disk (KeyCF) OPT
Data safety backup. Backup - Restore. OPT
New set of gains and accelerations. INST
MSGFILE: Number of PLC messages and errors expanded to 255 and 128 respectively. INST / OPT
Faster rigid tapping without sending M functions to the PLC. INST
Withdrawal of axes when interrupting a threading operation. INST / PRG
Spindle override change while threading. INST / PRG
Threading in blind threads (without thread exit) OPT / PRG
Jogging in G95. PRG
List of features Manual
Do not execute a program sent via DNC until pressing START. INST
Select the set of gains and accelerations to be used in a home search. INST
Prevent motion blocks from being executed in square corner mode. INST / PRG
There are now more zero offsets. PRG
The labels can now have 8 digits. PRG
Editing on hard disk (KeyCF) on CNC's without memory expansion. OPT
List of features Manual
Spindle home search on the next revolution after detecting that the home switch has been
pressed.
INST
Starting the CNC up while FAGOR filters are active. INST
Larger numeric format to define the arc center in a G2/G3. PRG
Monitoring the offset between the spindle and the longitudinal axis during rigid tapping. INST / OPT
Hysteresis in the reversal movement compensation command. INST
New default value for a.m.p. INPOSW2 (P51). INST
Setting the CNC in Turkish. INST
G86/G87. Threading cycles with variable pitch. PRG
List of features Manual
Improved Look-Ahead function:
• Advanced look-ahead algorithm (integrating FAGOR filters).
• Look-ahead operation with FAGOR filters active
• Smoother machining speed.
INST / PRG
To Next Page
Loading...
