Installation manual
CNC 8035
CONCEPTS
Fagor handwheels: HBA, HBE and LGB
5.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·245·
DFD HDWON = MOV 0 R61 = CNCWR(R61,HBEVAR,M201)
If JOG movement (JOGON) and [+] key pressed: "I75", then axis movement in the positive direction.
JOGON AND I75 AND XSEL = AXIS+1
JOGON AND I75 AND YSEL = AXIS+2
JOGON AND I75 AND ZSEL = AXIS+3
JOGON AND I75 AND 4SEL = AXIS+4
JOGON AND I75 AND 5SEL = AXIS+5
JOGON AND I75 AND 6SEL = AXIS+6
JOGON AND I75 AND 7SEL = AXIS+7
If JOG movement (JOGON) and [-] key pressed: "I77", then axis movement in the negative direction.
JOGON AND I77 AND XSEL = AXIS-1
JOGON AND I77 AND YSEL = AXIS-2
JOGON AND I77 AND ZSEL = AXIS-3
JOGON AND I77 AND 4SEL = AXIS-4
JOGON AND I77 AND 5SEL = AXIS-5
JOGON AND I77 AND 6SEL = AXIS-6
JOGON AND I77 AND 7SEL = AXIS-7
If JOG movement (JOGON) and [Rapid] key pressed: "I76", axis movement in rapid.
JOGON AND I76 = MANRAPID
Safety. When releasing the "Enable Push Button", the STOP command is sent out to the CNC (100
ms pulse) to stop the possible movement active at the time (for example: 10 mm in incremental).
Only if the JOG mode is selected and NOT MDI
DFD I79 = TG1 17 100
MANUAL AND NOT MDI AND T17 = NOT /STOP
END
In order to comply with the EN 61000 - 4 - 4 (IEC 1000 - 4 - 4) regulation on "immunity
against rapid transients and blasts" use a 7x1x0.14 PVC shielded cable for the 5 V
feedback cable.
To Next Page
Loading...
