Installation manual
CNC 8035
6.
PLC RESOURCES
Outputs
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·266·
6.2 Outputs
They are elements that let the PLC activate or deactivate the various devices of the electrical cabinet.
They are represented by the letter O followed by the output number which is desired to reference,
for example O1, O25, O102, etc.
The PLC may control 512 outputs although when communicating with the outside world it can only
access the physical ones.
Local physical outputs are the ones corresponding to the central unit.
Output O1 coincides with the emergency output of the CNC (connector); thus, it must be kept high
(logic level 1).
To Next Page
Loading...
