Installation manual
CNC 8035
6.
PLC RESOURCES
Marks
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·268·
They can be named by means of mark M4500-M4627 or by means of their associated mnemonic
ERR1 - ERR128:
Because the PLC program is not interrupted by these marks, it is advised to make it possible to
change their status via accessible external inputs; otherwise, the CNC will keep receiving the same
error at every PLC scan (cycle) thus preventing access to any PLC mode.
CNC user screens 0 through 255 may be activated by actvating each mark M4700 through M4955
They can be named by means of mark M4700-M4955 or by means of their associated mnemonic
PIC0 - PIC255:
The PLC has marks M5000 through M5957 to exchange information with the CNC, all of which have
associated mnemonics. See chapter "10 Logic CNC inputs and outputs".
M4500 M4501 M4502 -------- M4626 M4627
ERR1 ERR2 ERR3 -------- ERR127 ERR128
M4700 M4701 M4702 -------- M4954 M4955
PIC0 PIC1 PIC2 -------- PIC254 PIC255
To Next Page
Loading...
