Fagor 8035-T - Access to the PLC from the CNC

 Installation manual
CNC 8035
9.
CNC-PLC COMMUNICATION
Access to the PLC from the CNC
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·326·
9.4 Access to the PLC from the CNC
The CNC is provided with an operating mode in which it can:
• Monitor the user PLC program.
• Monitor PLC resources.
• Modify PLC resources.
• Execute PLC commands (compile, execute, etc.).
• Etc.
Likewise, the CNC allows access to all PLC variables of any part program and is provided with
several high level language instructions for this purpose, which allow Inputs, Outputs, Marks,
Registers, Timers and Counters to be read or modified.