Installation manual
CNC 8035
10.
LOGIC CNC INPUTS AND OUTPUTS
General logic outputs
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·356·
MSTROBE (M5532)
The CNC sets this signal high to tell the PLC that it must execute the auxiliary M function or functions
which are indicated in registers "MBCD1" to "MBCD7" (R550 to R556).
SSTROBE (M5533)
This signal will be used when operating a spindle with BCD coded S signal. s.m.p. SPDLTYPE (P0).
The CNC sets this signal high to tell the PLC that it must execute the auxiliary S function which is
indicated in the register "SBCD" (R557).
TSTROBE (M5534)
The CNC sets this signal high to tell the PLC that it must execute the auxiliary S function which is
indicated in the register "TBCD" (R558).
In this register the CNC will tell the PLC the position of the magazine where the selected tool is.
If the g.m.p. RANDOMTC (P25) has been set so it is not a random magazine, the magazine pocket
position coincides with the tool number.
T2STROBE (M5535)
This register is used when a special tool change has been made, family code or 200 or with
machining centers with a non-random tool magazine (g.m.p. RANDOMTC (P25).
The CNC sets this signal high to tell the PLC that it must execute a second auxiliary T function
indicated in the register "T2BCD" (R559).
In this register the CNC indicates to the PLC the position of the magazine in which the tool which
was on the spindle must be placed.
Feedrate override 2%
0 001100 0 18
Feedrate override 4%
0 010100 0 28
Feedrate
override10%
0 011100 0 38
Feedrate override
20%
0 100100 0 48
Feedrate override
30%
0 101100 0 58
Feedrate override
40%
0 110100 0 68
Feedrate override
50%
0 111100 0 78
Feedrate override
60%
1 000100 0 88
Feedrate override
70%
1 001100 0 98
Feedrate override
80%
1 010100 0 A8
Feedrate override
90%
1 011100 0 B8
Feedrate override
100%
1 100100 0 C8
Feedrate override
110%
1 101100 0 D8
Feedrate override
120%
1 110100 0 E8
SELECTOR
bit (7) bit (6) bit (5) bit (4) bit (3) bit (2) bit (1) bit (0) Hex.
SELECT7 ... ... SELECT0
To Next Page
Loading...
