Installation manual
CNC 8035
10.
LOGIC CNC INPUTS AND OUTPUTS
General logic outputs
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·358·
DM06 (M5541)
The CNC sets this signal high to tell the PLC that the spindle is stopped or that the auxiliary function
M06 is programmed in the block being executed (tool change).
DM08 (M5540)
The CNC sets this signal high to tell the PLC that the coolant output is activated or that the auxiliary
function M08 is programmed in the block being executed.
DM09 (M5555)
The CNC sets this signal high to tell the PLC that the coolant output is deactivated or that the auxiliary
function M09 is programmed in the block being executed.
DM19 (M5554)
The CNC sets this signal high to tell the PLC that it is working with spindle orientation or that the
auxiliary function M19 is programmed in the block being executed.
DM30 (M5553)
The CNC sets this signal high to tell the PLC that the auxiliary function M30 (program end) is
programmed in the block being executed.
DM41 (M5552)
The CNC sets this signal high to tell the PLC that the first spindle gear is selected or that the auxiliary
function M41 is programmed in the block being executed.
DM42 (M5551)
The CNC sets this signal high to tell the PLC that the second spindle gear is selected or that the
auxiliary function M42 is programmed in the block being executed.
DM43 (M5550)
The CNC sets this signal high to tell the PLC that the third spindle gear is selected or that the auxiliary
function M43 is programmed in the block being executed.
DM44 (M5549)
The CNC sets this signal high to tell the PLC that the fourth spindle gear is selected or that the
auxiliary function M44 is programmed in the block being executed.
RETRACT (M5567)
In drilling, tapping and rigid tapping cycles of the mill model CNC, it is now possible to withdraw the
tool to the starting plane and, once there, stop the spindle.
Once the retraction has been completed, the user will have the choice to finish the hole, go to the
next one or go into tool inspection.
General logic output RETRACT (M5567) is activated at the end of the stop and canceled when the
retraction in drilling or mill type threading has ended.
In the retraction of axes in the lathe model, general logic output RETRACT (M5567) is activated when
pressing [STOP] and the CNC begins the retraction (withdrawal). This mark stays active until the
retraction distances set in G233 are reached.
TMINEM (M5569)
Mark that is activated when the CNC detects an error during a tool change. This mark stays in
memory until it is canceled by the RESTMEM mark or using the [REMOVE ERROR] option that
appears in the error message.
To Next Page
Loading...
