Installation manual
CNC 8035
10.
LOGIC CNC INPUTS AND OUTPUTS
Spindle logic outputs.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·362·
REVOK (M5956) Main spindle
The CNC only considers the signals for the currently selected spindle.
When working with M03 and M04 the CNC sets this signal high to tell the PLC that the real spindle
revolutions correspond to those programmed.
The CNC will activate this signal every time the real revolutions are within the range defined by s.m.p.
"LOSPDLIM" and "UPSPDLIM".
When working with the spindle in closed loop (M19), the CNC sets this signal high if the spindle is
stopped.
INPOSS (M5957) Main spindle
This signal is used when working with the spindle in closed loop (M19). The CNC only considers
the signals for the currently selected spindle.
The CNC sets this signal high to tell the PLC that the spindle is in position.
To Next Page
Loading...
