Fagor 8035-T - Variables Associated with Tools

 Installation manual
CNC 8035
ACCESS TO INTERNAL CNC VARIABLES
Variables associated with tools.
11.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·369·
11.1 Variables associated with tools.
These variables are associated with the tool offset table, tool table and tool magazine table, so the
values which are assigned to or read from these fields will comply with the formats established for
these tables.
Tool table for mill model CNC
The radius (R), length (L) and wear offset (I, K) values of the tool are given in the units set by g.m.p.
INCHES.
If, INCHES = 0, in ten-thousandths of a millimeter (±999999999).
If INCHES = 1, in hundred-thousandths of an inch (±393700787).
If rotary axis, in ten-thousandths of a degree (±999999999).
Tool table for lathe model CNC
The length (X, Z), radius (R) and wear offset (I, K) values of the tool are given in the units set by
g.m.p. INCHES.
If, INCHES = 0, in ten-thousandths of a millimeter (±999999999).
If INCHES = 1, in hundred-thousandths of an inch (±393700787).
If rotary axis, in ten-thousandths of a degree (±999999999).
The location (tool shape) code (F) will be an integer between 0 and 9.
Tool table at the mill model CNC
The tool offset number is an integer between 0 and 255. The maximum number of tool offsets is
limited by g.m.p. NTOFFSET.
The family code is a number between 0 and 255.
0 to 199 if it is a normal tool.
200 to 255 if it is a special tool.
The nominal life is given either in minutes or in operations (0··65535).
The real (actual) life is given either in hundredths of a minute (0··9999999) or in operations
(0··999999).
Tool table at the lathe model CNC
The tool offset number is an integer between 0 and 255. The maximum number of tool offsets is
limited by g.m.p. NTOFFSET.
The family code is a number between 0 and 255.
0 to 199 if it is a normal tool.
200 to 255 if it is a special tool.
The nominal life is given either in minutes or in operations (0··65535).
The real (actual) life is given either in hundredths of a minute (0··9999999) or in operations
(0··999999).
The cutter angle is given in ten-thousandths of a degree (0··359999).
The cutter width is given in the units set by g.m.p. INCHES.
If, INCHES = 0, in ten-thousandths of a millimeter (±999999999).
If INCHES = 1, in hundred-thousandths of an inch (±393700787).
If rotary axis, in ten-thousandths of a degree (±999999999).
The cutting angle is given in ten-thousandths of a degree (0··359999).