Fagor 8035-T - Page 372

 Installation manual
CNC 8035
11.
ACCESS TO INTERNAL CNC VARIABLES
Variables associated with tools.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·372·
TOKn
This variable allows the value assigned to the wear in length (K) of the indicated tool offset (n) to
be read or modified in the tool offset table.
Read-and-write variables of the lathe model
TOXn
This variable allows reading or modifying the length value along the X axis assigned to the indicated
tool offset (n).
TOZn
This variable allows reading or modifying the length value along the Z axis assigned to the indicated
tool offset (n).
TOFn
This variable allows reading or modifying the location code (F) of the indicated tool offset (n).
TORn
This variable allows reading or modifying the radius R value of the indicated tool offset (n).
TOIn
This variable allows reading or modifying the length wear value (I) along the X axis of the indicated
tool offset (n).
TOKn
This variable allows reading or modifying the length wear value (K) along the Z axis of the indicated
tool offset (n).
NOSEAn:
This variable allows reading or modifying the cutter angle assigned to the indicated tool (n) in the
tool table.
NOSEWn
This variable allows reading or modifying the cutter width assigned to the indicated tool (n) in the
tool table.
CUTAn
This variable allows reading or modifying the cutting angle assigned to the indicated tool (n) in the
tool table.
CNCRD (TOX3, R100, M102)
Loads R100 with the length value along X of the tool offset 3.
CNCWR (R101, TOX3, M101)
Assigns the value indicated in R101 to the length along X of tool offset 3.