Fagor 8035-T - Chapter 13 Plc Programming Example; Definition of Symbols (Mnemonics)

 Installation manual
CNC 8035
13.
PLC PROGRAMMING EXAMPLE
Definition of symbols (mnemonics)
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·410·
13.1 Definition of symbols (mnemonics)
It is a possible to associate a symbol (name) to any PLC resource. It may have up to 8 characters
so long as the name does not coincide with any of the reserved instructions. It may not contain the
following characters: blank-space " ", equal sign "=", parenthesis "(" or ")", comma "," or semi-colon
";".
These symbols or names must always be defined at the beginning of the program. Duplicate
symbols cannot be defined; but several symbols may be assigned to the same resource.
For better clarification, the symbols used in this program are grouped by subjects.
Used in: Basic and necessary programming.
Used in: Treatment of the axis travel limit switches.
Used in: Treatment of the machine reference (home) switches.
Used in: Treatment of M, S, T functions.
Used in: Machine way lubrication.
DEF I-EMERG I1 External emergency input.
DEF I-CONDI I70 Conditional mode. The CNC interrupts part-program execution
when executing auxiliary function M01
DEF SERVO-OK I71 The servo drives are O.K.
DEF O-EMERG O1 Emergency output. It must be normally high.
DEF I-LIMTX1 I72 X axis positive overtravel limit switch
DEF I-LIMTX2 I73 X axis negative overtravel limit switch
DEF I-LIMTY1 I74 Y axis positive overtravel limit switch
DEF I-LIMTY2 I75 Y axis negative overtravel limit switch
DEF I-LIMTZ1 I76 Z axis positive overtravel limit switch
DEF I-LIMTZ2 I77 Z axis negative overtravel limit switch
DEF I-REF0X I78 X axis home switch
DEF I-REF0Y I79 Y axis home switch
DEF I-REF0Z I80 Z axis home switch
DEF M-03 M1003 Auxiliary mark. Indicates that M03 must be executed
DEF M-04 M1004 Auxiliary mark. Indicates that M04 must be executed
DEF M-08 M1008 Auxiliary mark. Indicates that M08 must be executed
DEF M -41 M1041 Auxiliary mark. Indicates that M41 must be executed
DEF M -42 M1042 Auxiliary mark. Indicates that M42 must be executed
DEF I-LUBING I81 Operator request to lubricate the ways of the machine
DEF O-LUBING O2 Ways lubrication output